If it is not there you can find the official version here. You might find it in /boot/overlays/README on your SD-card. You should also check the README for details on the overlays. You should now be able to use Razberry Z-Wave from /dev/ttyAMA0.įor other operating systems such as Raspberry Pi OS you will also have to run the following command: sudo systemctl disable hciuart Raspberry Pi 3 procedureįor Home Assistant OS this should be everything you need to do. Then shutdown, add the hat back, and boot again. Ive also used a Zooz ZST10, a Nortek HUSBZB-1 (came with my C-3 but I moved Zigbee to a different hub later on so didnt need it for that anymore), and a 700-series stick similar to the. At the top right the node management button houses the 'groups & network' button. Click this and the list of controlled nodes appears. To remove a Z-Wave device from the network, simply go to the device with. If there is a Z-Wave controller in the system (a USB-stick for instance), there is a 'Setup' button beside it. Reboot your Pi 4 without the Razberry Z-Wave hat first. I normally use an Aeon Z-Stick (because its what Im using as the primary Z-Wave controller on my C-3 hub), but pretty much any Z-Wave USB stick should work. The Z-Wave network info screen is available under Setup > hardware. apply hard reset to the zwave controller, which is not a practical option. Do It Yourself Know How Using UPB, Insteon, X10 and Z-Wave Dennis C Brewer. put the controller into exclusion mode and click the device to exclude it, but the device is dead. The instructions of the z-wave stick tells to either.
![aeon labs z-stick series 2 aeon labs z-stick series 2](https://user-images.githubusercontent.com/668449/37101976-0df7048c-2227-11e8-9fdd-58ae9fa74279.png)
Raspberry Pi 4 procedureĪdd the following parameters to the bottom of the /boot/config.txt file. Deleting the thing from PaperUI will not remove it from the controller memory. The Aeon Labs Z-Stick (DSA02203AU) is a self-powered Z-Wave USB dongle with push button for remote network creation (independent from external power and host microprocessor).
#AEON LABS Z STICK SERIES 2 PC#
You do this by adding the following to the end of /boot/config.txt:įor both processes below you will need to insert your SD card into your PC and open the /boot/config.txt file with your favorite text editor.
#AEON LABS Z STICK SERIES 2 BLUETOOTH#
You need to disable the on-board Bluetooth since the board requires the use of the hardware UART (and there’s only one on the Pi3). It’s totally normal for your Z-Wave stick to cycle through its LEDs (Yellow, Blue and Red) while plugged into your system. Both hardware revisions are still being sold, make informed purchasing decisions if using paired with a Pi 4. Aeotec has released a 2020 hardware revision ZW090-A/B/C Gen5+ with Pi 4 compatibility.
![aeon labs z-stick series 2 aeon labs z-stick series 2](https://m.media-amazon.com/images/I/51NZ-KqHTGL._AC_SL1000_.jpg)
There are known compatibility issues with older hardware versions of the Aeotec stick not working on the Raspberry Pi 4.